Olympus EPOCH 600 - Alkaline Batteries

DMTA‐10007‐01EN[U8778365],Rev. B,June2010
22Chapter1
1.4.3 Alkaline Batteries
TheEPOCH 600comesstandardwithanalkalinebatteryholder(P/N:600‐BAT‐AA
[U8780295]).Thisholderaccommodates8AAsizealkalinebatteriesinsituations
whereanACpowersourceisnotavailableandtheinternalLi‐ionbatteryis
discharged.Whenoperatedundertypicalinspectionconditions,thealkalinebatteries
willprovide3+ hoursof
continuousoperation.
To install the alkaline battery holder
1. Unfoldtheinstrumentpipestand.
2. Loosenthetwothumbscrewssecuringthebatterycompartmentcov erattheback
oftheinstrument,andthenremovethebatterycompartmentcover(see
Figure 1‐10onpage 23).
3. Removethelithium‐ionbattery(ifinstalled)[seeFigure 1‐10onpage 23].
Green Yes ACcharger/adaptorconnected
Nobatteryinstalled
Table 2ACcharger/adaptorpowerindicatorstatus(continued)
Power
indicator
status
AClinepower
connected
Indicatormeaning
Battery
indicator