6
2.2 Wall Mounting
Position unit where required. Mark and drill the two #4 screw holes.
After bracket is mounted on the wall, align back of unit over the three bracket clips, once
engaged, slide downward, the unit will snap in place.
61.6 [2.42]
38.1 [1.50] 11.7 [0.46 ]
REAR WIRE
ENTRY AREA
DRILL 3.17 [0.125]
USE TWO, #4
FLAT HEAD SCREWS
TO MOUNT BRACKET
BRACKET CLIPS (3)
SNAP
Figure 2.2 Wall Mounting
It is recommended that you ground your unit by connecting a wire to the Return/
Ground position of the relay connector, see Figure 2.6.
Dimensions are in mm
with inches in [ ].
To Next Page
Loading...
