Omega iServer MicroServer iTHX-SD - Parts of the Iserver Unit; Figure 2.3 Parts of the Iserver Unit; Table 2.1 Parts of Iserver Unit

7
2.3 Parts of the iServer Unit
1
8
1
Figure 2.3 Parts of the iServer Unit
Table 2.1 Parts of iServer Unit
ETHERNET RJ45 interface for 10/100BASE-T connection.
RESET Button: Momentary (Push and Release) resets power on unit; Push and Hold for
10 seconds to reset unit to factory defaults and reset power.
100 BASE-T LED (Green) On: Indicates 100 Mbps; LED Off: Indicates 10 Mbps.
LINK/ACT LED (Green) On/Blinking: Indicates good network link and network activities
(receiving or sending packets).
DHCP LED (Yellow): When DHCP is enabled, once the iServer receives the IP
parameters from the DHCP server this LED will turn Solid yellow.
RECORDING LED (Green) Blinking Fast: Indicates that the unit is recording. LED Blinking:
during back-up battery operation according to sampling rate, or recording interval
if recording is ON.
°C/°F Button: Press to change LCD display units of measurement between °C and °F.
Press and Hold along with TIME/IP button during power-on, this will enable
DHCP mode.
TIME/IP Button: Press repeatedly to change LCD display from: 1) Date and Time;
2) Temperature and Humidity; 3) iServer’s IP address. Press and Hold
along with °C/°F button during power up, this will enable DHCP mode.
The 9V battery is the
back-up power for the
recording function only.