Omega iServer MicroServer iTHX-SD - Httpget Program; Figure 4.37 Telnet to Port 2002 - P Command; Figure 4.38 Telnet to Port 2002 -? Command

47
4.8.1 Telnet Connection (continued)
Figure 4.37 F igure 4.38
Telnet to port 2002 – p command Telnet to port 2002 – ? command
4.9 HTTPget Program
The HTTPget software is used to send a single HTTP or TCP request to an iServer
product. In contrast, the telnet or Hyperterminal programs allow a continuous
connection with multiple requests to be sent to the iServer product.
Generally HTTPget is used for simply programming an IP address to the iServer or for
quickly obtaining a reading of from a device.
The iServer product must be configured from the configuration web page so that the
“Server Type” value is set to “Command”, refer to Section 4.4.3.2.