Omega iServer MicroServer iTHX-SD - Disassembly Instruction; Figure 2.4 Opening the Unit

8
2.3 Parts of the iServer Unit (continued)
STBY Button: 1) Stops the recording 2) Press before ejecting Flash Card.
NOTE: display will show “Safe to Eject SD” after button has been pressed.
BKLT Button: Push and Hold to display Backlight on LCD when it is running on the
back-up battery (backlight is always on while running on the ac adapter).
2.4 Disassembly Instruction
You may need to open the unit for one of the following reasons:
W To wire relay connector. (Refer to Figure 2.6)
W To connect or replace the battery.
Disconnect the power supply before proceeding.
W Make sure the flash memory card is fully inserted (or removed), before removing the
cover.
W Remove probe from handle clip (if needed).
Remove cover, by removing 2 mounting screws on each side.
MOUNTING
SCREWS (2)
KEEP INSULATOR
COVER ON BATTERY
CLIP WHEN BATTERY
IS NOT BEING USED
COVER
TRAY
FLASH
CARD
REMOVE BATTERY CLIP
INSULATOR COVER AND
STORE WHERE SHOWN
WHEN 9V BATTERY IS
BEING USED.
RELAY
CONNECTOR
POWER ADAPTOR
Figure 2.4 Opening the Unit
Press STBY before
ejecting Flash Card.
Display will show “Safe
to Eject SD” after button
has been pressed.