Omega PLATINUM Series User Manual

PLATINUM
TM
Series Controllers User’s Guide
M5451 Omega Engineering | www.omega.com
10
Wiring Instructions
Ethernet Communications Status
LEDs if EIP Option Installed
USB Connector (on side,
shown with cable stub)
8-Pin Power / Base Outputs Connector
10-Pin Input Connector
Ethernet Connector if EIP Option Installed
3. Wiring Instructions
3.1 Back Panel Connections
Figure 1 – CN8Pt, CN8DPt and CN8EPt Models: Back Panel Connections
(No Isolated Output Expansion Board Installed)
Figure 2 – CN8Pt, CN8DPt and CN8EPt Models: Back Panel Connections
(With Isolated Output Expansion Board)
10-Pin Input Connector
8-Pin Power / Base Outputs Connector
USB Connector (on
side, not visible here)
Ethernet Communications Status
LEDs if EIP Option Installed
Ethernet Connector if EIP Option Installed
Optional Isolated Output Expansion
Connector

Omega PLATINUM Series Specifications

General

Protection Class	IP20
Input Type	Thermocouple, RTD, Process
Output Type	Relay, SSR
Control Mode	ON/OFF, PID
Display Type	LED
Power Supply	100-240V AC, 24V DC
Communication	RS-485
Input Voltage	0 to 10 VDC
Output Voltage	0 to 10 VDC
Operating Temperature	0-50°C
Sampling Rate	100ms