CP TD1 User Manual
10 OMICRON
1.5 Orderly measures
The CP TD1 User Manual or alternatively the e-book in PDF format has always to be available on site
where the CP TD1 is being used. It must be read and observed by all users of the CP TD1.
The CP TD1 may be used only as described in this User Manual. Any other use is not in accordance
with the regulations.
The manufacturer and/or distributor is not liable for damage resulting from improper usage. The user
alone assumes all responsibility and risk.
Following the instructions provided in this User Manual is also considered part of being in accordance
with the regulations.
Opening CP TD1 or its accessories invalidates all warranty claims.
1.6 Static charges
Static charges on bushings or other apparatus such as transformer windings may be induced by test
potentials. While the voltage may not be significant enough to do any damage to the equipment, it can
be a source for serious accidents due to falls caused by reflex action.
High static charges may also be encountered at the bushing capacitance taps if the covers are removed.
► Use safety grounds before handling.
Always observe the five safety rules!
1.7 Disclaimer
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
To Next Page
Loading...
Need help?
General
