Omnitracs MCP110 - Page 41

80-JB400-1 Rev. D 4-5
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Installation Planning Conventional Vehicle Types
International/Navistar 8600 Series
• MAS110—Install on side wall or under bunk.
- Install so there is access to a USB port for the
memory stick and access to backup battery.
•DIU110—Install on dash where space allows/customer
preference.
• Cables—Route externally or internally.
- Drill a 1" hole for antenna cable.
• Typical Connection Points
- Power: passenger side fuse panel red wire A13AF A13 - fuse slot F38
- Chassis ground: driver side firewall post
- Ignition: passenger side fuse panel, pink wire A13F - fuse slot F28
- J1708: driver side steering column. wires A3C+, A3C-. Recommend the use of Packard
style female terminals - International part #16612094.
- J1939: driver side kick panel, 9-pin Deutsh connector
- TTRACS: outside driver cab at 7-way harness to OEM harness junction
Freightliner Cascadia
• MAS110—Install on side wall or under bunk.
- Install so there is access to a USB port for the
memory stick and access to backup battery.
•DIU110—Install on dash where space allows/customer
preference.
• Cables—Route internally.
- Use existing 1" hole for antenna cable.
• Typical Connection Points
- Power: center lower dash, main bus bar
- Chassis ground: center lower dash, main bus bracket
- Ignition: center lower dash, main bus bar, ignition terminal block
- J1708: 6-pin Deutsch connector (pin A+, pin B -), 9-pin Deutsch connector (pin F+, pin
G-)
- J1939: 9-pin Deutsch connector Green (+) and Yellow (-) wires
- TTRACS: reference OEM wiring specs
Power-
Main
Power Bus
MAS
International/Navistar
Key
Switch
Display
Electrical
Panel
Antenna cable
access hole
MAS
Freightliner
Existing
heater
box
A pillar