Omnitracs MCP110 - Tools and Supplies Recommended for Installations; Omnitracs Approved Sealants

80-JB400-1 Rev. D 4-11
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Installation Planning Tools and Supplies Recommended for Installations
Tools and Supplies Recommended for Installations
Omnitracs Approved Sealants
Essential Tools Miscellaneous Tools
• Standard Combination Wrench Set Measuring Tape
• Diagonal Wire Cutters Rachet/Sockets
• Wire Strippers Adjustable Wrench
• 3/8" Drive Standard Deep Well Socket Set with
rachet
Level
• Butt Splice Crimping Tool Debur Tool
• Screwdrivers: Phillips #2 and Slotted Flush Cutters
• Torx Drivers: #10, #20, #25 Hacksaw
• Volt/ohm Meter Hammer
• 1/4" Drill Bit and assorted size bits Utility Knife
• 1" Hole Saw Files (flat, round)
• 3/8" Cordless Drill (this will speed up installation
time)
Channel Locks
• Radio Removal Tool “U” Straight Awl
1/4" Drive Standard Deep Well Socket Set
with rachet
Miscellaneous Supplies
• Silicone Sealant or Refrigeration/Tar Tape Flash/Drop Light
• Assorted Ring Terminals
• Assorted Butt Splices
• Electrical Tape
Items marked with a bullet (•) are considered necessary, must-have tools and supplies required to
perform an installation. Additional tools may be required to facilitate certain installations and for
maintenance.
Sealant, Lubricant, or Liquid Acceptable For Required For
Refrigeration/tar tape
(supplied)
Sealing exterior to interior
holes.
Sealing 1" hole for
antenna cable.
Silicone sealant Sealing exterior to interior
holes.
Sealing bolt holes for
antenna mounting
brackets.