Omnitracs MCP110 - Cabover Engine Vehicle Types (All Makes); Special Cable Ordering Instructions for Tilt Cabs

Cabover Engine Vehicle Types (All Makes) Installation Planning
4-10 80-JB400-1 Rev. D
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Cabover Engine Vehicle Types (All Makes)
• MAS110—Install on side wall or under bunk.
- Install so there is always access to a USB port for the
memory stick.
•DIU110—Install on dash where space allows/customer
preference.
• WIB100—30 foot WIB cable will be needed.
• Cables—Route internally.
- Connect power cable to main bus or keyswitch.
- Drill a 1" hole in floor of side box for antenna cable.
Special Cable Ordering Instructions for Tilt Cabs
• Typically, the antenna cable must be routed through the
cab pivot point to allow for the tilt.
• In most tilt cab vehicles, this routing requires a longer
cable than the standard cable. 30 foot max.
• When ordering the MCP110, specify the length of the
cable(s) you need.
MAS
Antenna cable
access hole
Display
Electrical
Panel
Cabover Engine
Tilt Cab
Pivot Point
Display
Unit
Power Bus/
Key
Switch
MAS
Longer
Cable
WIB
Tilt Cab