Omnitracs MCP110 - Flowchart-Basic MCP110 System Verification

Flowchart—Basic MCP110 System Verification System Verification
10-6 80-JB400-1 Rev. D
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Flowchart—Basic MCP110 System Verification
Turn ignition
ON
Step 2
Move unit to
acquire
network
signal
Step 1
System_Flow_1_MCP110
Step 3
Good
Step 4
See Chapter 6
Communication
Problem
Troubleshooting
in the MCP110
Diagnostic Guide
See Chapter 6
Communication
Problem
Troubleshooting
in the MCP110
Diagnostic Guide
Run all tests.
Bad
Step 6
Was message
acknowledged
by dispatcher?
Step 5
Display
Message screen.
Send test message
to dispatcher
Step 7
Have dispatcher
send test
message to
MCP110
No
Yes
Yes
Go to Step 8
Check for
appropriate green
checkmarks