Omnitracs MCP110 - Page 5

80-JB400-1 Rev D
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Contents
Text-to-Speech (TTS) Installation
General Installation Guidelines .........................................................................8-2
Selecting a Speaker ..........................................................................................8-2
Speaker Requirements ...............................................................................8-2
Choosing a Speaker ...................................................................................8-2
Option 1—Connecting to an Existing or Shared Speaker .................................8-3
Connecting Speaker Switch Cable to Accessory Cable .............................8-4
Option 2—Connecting to a Dedicated 8-ohm Speaker .....................................8-6
Vehicle Data Bus Connections
Vehicle Data Source Overview .........................................................................9-2
J1939 Data Bus ..........................................................................................9-2
J1708/J1587 Data Bus ...............................................................................9-2
Traditional Sensors ....................................................................................9-2
Vehicle Data Source Selection .........................................................................9-3
Guidelines for Connecting to the J1939 Data Bus ............................................9-3
J1939 Pre-installation Check Out .....................................................................9-4
Resistance Test (to Verify that J1939 Is Present) ......................................9-4
Option 1—Connecting J1939 Using the Repeater Cable .................................9-5
Making the Connection ...............................................................................9-5
Option 2—Connecting J1939 Without Using the Repeater Cable ....................9-8
Making the Connection................................................................................9-9
Connecting J1708 /J1587 ...............................................................................9-10
Verifying Data Source Connectivity ................................................................9-12
System Verification
What Is Basic MCP110 System Verification? .................................................10-2
How to Find the MCP110 Unit Address (UA) ...........................................10-2
Performing System Verification .................................................................10-3
MCP110 Diag Screen................................................................................10-4
Flowchart—Basic MCP110 System Verification .............................................10-6
Basic MCP110 System Verification Procedure ...............................................10-8
MCP System Screens ...................................................................................10-12
MCP110 System Screen ........................................................................10-12
MCP110 Comm Screen .........................................................................10-13
MCP110 GPS Screen .............................................................................10-14
MCP110 Performance Screen ...............................................................10-15
VDS Screen.............................................................................................10-16
Omnitracs MCP110 System Verification Form .............................................10-16