5-90
5-7 Digital Operator/Operation Functions
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
5
Functions
Basic Display (b037=04)
The basic parameters are displayed (factory defaults).
The following parameters are displayed when this function is enabled:
Monitor Display Only (b037 = 05)
Displays the Monitor Display (b037) for d***.
No. Parameter No. Function name
1 d001 to d104 Monitor Display
2 F001 Output Frequency Setting
3 F002 Acceleration Time Setting 1
4 F003 Deceleration Time Setting 1
5 F004 RUN Direction Selection
6 A001 Frequency Reference Selection 1
7 A002 RUN Command Selection 1
8 A003 Base Frequency 1
9 A004 Maximum Frequency 1
10 A005 FV/FI Selection
11 A020 Multi-step Speed 1 Reference 0
12 A021 Multi-step Speed Reference 1
13 A022 Multi-step Speed Reference 2
14 A023 Multi-step Speed Reference 3
15 A044 Control Method 1
16 A045 Output Voltage Gain 1
17 A085 RUN Mode Selection
18 b001 Retry Selection
19 b002 Allowable Momentary Power Interruption Time
20 b008 Overvoltage/Overcurrent Restart Selection
21 b011 Overvoltage/Overcurrent Restart Standby Time
22 b037 Display Selection
23 b083 Carrier Frequency
24 b084 Initialization Selection
25 b130
Overvoltage Suppression Function Selection During
Deceleration
26 b131 Overvoltage Suppression Level During Deceleration
27 b180 Perform-Initialization/Mode Selection
28 b190 Password A Setting
29 b191 Password A Authentication
30 C021 Multi-function Output Terminal P1/EDM Selection
31 C022 Multi-function Output Terminal P2 Selection
32 C036 Multi-function Relay Output (MA, MB) Contact Selection
To Next Page
Loading...
