Omron 3G3MX2 - Installation

2-1
2-1 Installation
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
2
Design
2-1 Installation
Precautions for Safe Use
Installation and Storage
 Do not store or use the product in the following places.
 Locations subject to direct sunlight.
 Locations subject to ambient temperature exceeding the specifications.
 Locations subject to relative humidity exceeding the specifications.
 Locations subject to condensation due to severe temperature fluctuations.
 Locations subject to corrosive or flammable gases.
 Locations subject to exposure to combustibles.
 Locations subject to dust (especially iron dust) or salts.
 Locations subject to exposure to water, oil, or chemicals.
 Locations subject to shock or vibration.
Transportation, Installation, and Wiring
 Do not drop or apply any strong impact to the Inverter to avoid damage to the parts and/or
the Inverter.
 When transporting the Inverter, hold the fin, not the front cover or terminal block cover.
 Do not connect an AC power supply to the control I/O terminals. Doing so may cause damage
to the Inverter.
 Be sure to tighten the screws on the terminal block securely. Perform the wiring after
installing the Inverter.
 Do not connect any load other than the 3-phase induction motor to the output terminals (U/
T1, V/T2, W/T3) of the Inverter.
 Take appropriate and sufficient countermeasures when using the Inverter in the following
locations. Not doing so may result in damage to the Inverter.
 Locations subject to static electricity or other forms of noise.
 Locations subject to strong electromagnetic fields.
 Locations close to power supplies.
Main Circuit Power Supply
 Confirm that the rated input voltage of the Inverter matches the AC power supply voltage.