10 Interrupts
10-8
CP1E CPU Unit Software User’s Manual(W480)
1
PLC Setup
Set IN2 to Interrupt in the interrupt input settings on the Built-in Input Tab Page.
2
Connecting Interrupt Input Terminals
Terminal 2 on terminal block 0CH is interrupt input IN2.
Interrupt task 2 corresponds to interrupt input 2.
Sensor input 3: CIO 0.03
Sensor input 2: CIO 0.01
Sensor input 1: CIO 0.00
Interrupt input (sensor input):
CIO 0.02
Reset input: CIO 0.04
NG output 2: CIO 100.04
NG output 3: CIO 100.03
NG output 4: CIO 100.02
OK output: CIO 100.00
NG output 1: CIO 100.01
To Next Page
Loading...
