17-13
17 Ethernet Option Board
CP1E CPU Unit Software User’s Manual(W480)
17-3 Settings
17
17-3-3 Default Settings
The default settings of the Ethernet Option Board are shown in the following tables.
Make the initial settings by the Web browser function if the settings are not as follows.
• Common Settings of the FINS/UDP and FINS/TCP Methods
• Using the FINS/UDP Method
• Using the FINS/TCP Method
The following diagram describes how to restore the initial settings of the Ethernet Option Board.
17-3-3 Default Settings
Item Initial settings
IP Address 192.168.250.1
Subnet Mask 255.255.255.0
FINS Node Address 1
Baud Rate Auto
IP Router Table None (IP router not enabled)
Item Initial settings
FINS/UDP Port 9,600
Address Conversion Mode Auto (Dynamic)
IP Address Table None
FINS/UDP Option Destination IP address is changed
dynamically
Broadcast Option All ‘1’ (4.3 BSD)
Item Initial settings
FINS/TCP Port 9,600
FINS/TCP Connection Setup None
FINS/TCP Protected Use protection function according to IP
address
The initialization of the Ethernet
Option Board is completed.
Auxiliary Area Restart Flag
(A525.09) is turned ON.
OFF when the
Ethernet Option
Board
is restarted.
Auxiliary Area Initializing Flag
(A525.01) is turned ON.
OFF when the initialization is
completed.
Confirm A525.01 is OFF
Confirm A525.09 is OFF
To Next Page
Loading...
