Omron CP1E CPU UNIT SOFTWARE - Differences in Version of the Ethernet Option Board

17 Ethernet Option Board
17-8
CP1E CPU Unit Software User’s Manual(W480)
Precautions for Correct UsePrecautions for Correct Use
The differences between the Ethernet Option Board and the CS/CJ series Ethernet Unit are as follows.
• Connect with the CPU Unit by the Host Link (serial communications) whose internal baud rate is 115.2
kbps.
• The size of communications buffers is 8K bytes, one fifty of that of the CS/CJ series Ethernet Unit.
Therefore, the communication performance is slower than the CS/CJ series Ethernet Unit.
Refer to the following processing time (Netwok delay is not included), when accessing to the CP-series CPU
Unit through the Ethernet Option Board.
When accessing to the CP1E CPU Unit and reading 269 words from the DM area, if the cycle time of the
CPU Unit is 10 ms, the processing time will be more than 225 ms and less than 356 ms.
For the CS/CJ series CPU Unit who installs the Ethernet Unit, when executing the same task, the process-
ing time will be approximately 20 ms, up to 17 times faster.
CP1W-CIF41 Ethernet Option Board has two versions: version 1 and version 2. Only version 2 can be
used on the CP1E CPU Unit.
The CP1E CPU Unit does not support the Toolbus protocol, so the Ethernet Option Board version 1.0
cannot be used.
17-1-6 Differences in version of the Ethernet Option Board
Comparison with CP1W-CIF41 Version 1.0
Item CP1W-CIF41 version 1.0 CP1W-CIF41 version 2.0
Communications mode Toolbus (CP1L/CP1H) Toolbus (CP1L/CP1H)
Host Link (CP1E)
Reset system settings function Not supported Turn ON the Reset Flag A525.01 in
the Auxiliary Area.
Restart function Click the Restart Button from the
Web browser.
• Click the Restart Button from the
Web browser.
• Turn ON the Restart Flag A525.09
in the Auxiliary Area.
Max. number of units that can be
mounted
Cannot be used 1 set