18-21
18 Programming Device Operations
CP1E CPU Unit Software User’s Manual(W480)
18-4 Connecting Online to the CP1E and Transferring the Program
18
18-4-4 Starting Operation
To start operation, turn ON the power or change the operating mode to RUN mode.
Precautions for Correct UsePrecautions for Correct Use
Operation will not be started when the power is turned ON if the PLC Setup is set so that the
PLC enters PROGRAM mode at startup.
Use the following procedure to change the operating mode to RUN mode. To perform trial operation for
debugging or adjustments, change the operating mode to MONITOR mode.
Precautions for Safe Use
Always confirm the safety of the controlled system before changing to MONITOR or RUN mode.
4
Click the Yes Button.
5
Click the OK Button.
This completes transferring the lad-
der program.
18-4-4 Starting Operation
To Next Page
Loading...
