17-17
17 Ethernet Option Board
CP1E CPU Unit Software User’s Manual(W480)
17-3 Settings
17
17-3-4 Web Browser Setting Function
6
After entering the correct values, click the Transfer Button to transfer the settings to the Ethernet
Option Board.
7
To enable the new settings, turn the power to the Ethernet Option Board OFF and ON again, or
click the Restart Button.
The functions of the buttons are as follows.
System setup for the Ethernet Option Board is as follows.
Button Function
Transfer Transfer the entered values from the personal computer to the Ethernet Option
Board. (The new settings are invalid until the Ethernet Option Board has been reset.)
Cancel Cancel the entered values.
Restart Restart the Ethernet Option Board to enable the new settings after transfer.
The Restart button is invalid to the PLC.
System Format
Item Contents Default
IP Address Set the local IP address for the Ethernet Option Board.
• Setting range: 00.00.00.00 to 223.255.255.255
192.168.250.1
Subnet Mask Set the subnet mask for the Ethernet Option Board.
This is required if a method other than the IP address table method is
used for address conversion.
255.255.255.0
FINS Node Address Set the local FINS node address for the Ethernet Option Board.
• Setting range: 1 to 254
1
FINS/UDP Port Specify the local UDP port number to be used for the FINS communica-
tions service. The UDP port number is the number used for UDP identi-
fication of the application layer (i.e., FINS communications service).
• Setting range: 1 to 65,535
9,600
To Next Page
Loading...
