Omron CS1W-CRM21 - Page 76

54
CompoNet Network Wiring Section 3-2
■ Example for Round Cable I
Note Attach a M3 crimp terminal to the cable wire before you connect the wire to a
terminal block.
Flat Cable I or Flat Cable II
(with a Flat Connector
Socket and a Flat
Connector Plug)
Use a Flat Connector Socket and a Flat Connector Plug.
■ Example for Flat Cable I
Attach a DCN4-BR4 Flat Connector Plug to a DCN4-TR4 Flat Connector
Socket.
■ Example for Flat Cable II
Attach a DCN5-BR4 Flat Connector Plug to a DCN5-TR4 Flat Connector
Socket.
Note The same type of cable must be used for both the trunk line and the sub-trunk
line.
Slave Unit
Relay terminal block
6.0 mm max.
6.0 mm max.
Slave Unit
DCN5-TR4 Flat
Connector Socket
DCN5-BR4 Flat
Connector Plug
Slave Unit
DCN5-TR4 Flat
Connector Socket
DCN5-BR4 Flat
Connector Plug