Omron E5C series - Page 286

6 Parameters
6 - 54
E5@C Digital Temperature Controllers User’s Manual (H174)
tr-h
Transfer Output Upper Limit
There must be a transfer output.
The transfer output type must not be set to OFF.
tr-l
Transfer Output Lower Limit
• This parameter sets the upper and lower limit values of transfer outputs.
*1 The remote SP will be output while the SP Mode parameter is set to the Remote SP Mode.
*2 This function can be set for a Position-proportional Model, but the setting will be disabled.
*3 This function can be set for standard control or for a Position-proportional Model, but the setting
will be disabled.
*4 This setting is displayed only for a Position-proportional Model.
z Related Parameter
Transfer Output Type (Initial Setting Level): Page 6-53
000
000
Function
Setting
Transfer
output type
Setting range
Default
Unit
Transfer output
lower limit
Transfer output
upper limit
Set point
*1
SP lower limit to SP upper limit SP lower limit SP upper limit EU
Set point
during SP
ramp
SP lower limit to SP upper limit
PV Temperature
input
Input setting range
lower limit to input
setting range upper
limit
Input setting
range lower limit
Input setting
range upper
limit
Analog input Analog scaling
lower limit to analog
scaling upper limit
Scaling lower
limit
Scaling upper
limit
MV
(heating)
*2
Standard −5.0 to 105.0 0.0 100.0 %
Heating/
cooling
0.0 to 105.0
MV
(cooling)
*3
Valve
opening
*4
Position-
proportional
control
−10.0 to 110.0
See
See