1 Introduction
1 - 4
Digital Temperature Controllers (Simple Type) User’s Manual (H211)
1-2 I/O Configuration and Model Number
Legend
Note: Not all models support these functions. For details, refer to 1-2-2 Model Number Legends.
1-2-1 I/O Configuration
*
Functions can be assigned individually for each output by
changing the set values for the Control Output 1 and 2
Assignments and the Auxiliary Output 1 and 2 Assignments in
the parameters in the advanced function setting level.
E5CC/E5EC
Auxiliary outputs
1 and 2
• Input type • Input shift
• Input filter • Moving average
• Analog scaling
Input signals
• Direct/reverse
• Auto/manual
• Linear current
• Voltage output
(for driving SSR)
• Relay
Outputs
PV
Manipulated
value
(MV)
Limit
Output signals
A: 100 to 240 VAC
or
D: 24 VAC/DC
Multi-SP
Inputs
Set point (SP)
Control
Power supply
• Relay
Control output 1
Contact status
Operation
Process value (PV) input
• Thermocouple
• Resistance thermometer
• Infrared Temperature Sensor
• Analog input (current/voltage)
• Relay
Control output 2
•
PID
or
• O
N/OFF con
trol
Heating/cooling
*
*
*
SP
• SP ramp
• Set point limiter
Automatic setting of
PID constants with AT
or ST
• MV limit
• Standard control or
• Heating/cooling
control
Alarms
Event inputs (EV1 to EV4)
• External inputs
(contact or non-contact input)
•
Standard alarms (alarms 1 to 4)
• HB alarm
• HS alarm
• Input error (S.ERR)
•
Integrated alarm
•
RUN status
CT input
Input voltage from CT
• RUN/STOP switching •
Auto/manual selection
•
100% AT execute/cancel
• 40% AT execute/cancel
• Alarm latch cancel • Multi-SP No.
• Invert direct/reverse
operation
• Setting change
enable/disable
• Communications
write enable/disable
• RS-485
• CompoWay/F
• Modbus-RTU
Communications
• HB alarm
• HS alarm
To Next Page
Loading...
Need help?
General
