EasyManuals Logo

Omron E5CC-800 User Manual

Omron E5CC-800
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
3 - 3
3 Part Names and Basic Procedures
Digital Temperature Controllers (Simple Type) User’s Manual (H211)
3-2 Power ON
3
3-2 Power ON
Operation will start as soon as you turn ON the power supply to the E5CC/E5EC.
The following default settings will be used when operation starts.
After the power comes ON, all indicators and displays will light for approximately 1 second, and then the
operation display will appear.
The top display will show the PV and the bottom display will show the SP.
Input type 5: K thermocouple
ON/OFF control
Alarm: Upper-limit alarm*
Set point: 0°C
* If the Controller is equipped with HB/HS alarm detection, it is set by
default to detect heater alarms.
s.err
0
25
0
C
• Resistance Thermometer Connected
or
• Temperature Sensor Not Connected
• Thermocouple Connected
SP
*The default setting is 0°C.
s.err:
An input error
is displayed.
The default setting of the input type is for a K thermocouple.
The operation display appears.
Operation Level
Power ON
Everything
lights for
approx. 1 s.
The PV that is measured by the
temperature sensor is displayed.
K Thermocouple Connected:
The correct temperature is
displayed.
Other Thermocouple Connected:
The correct temperature is
not displayed.
If you are not using a K thermocouple, set
the Input Type parameter to the correct
sensor type in the Initial Setting Level.
Refer to step 2 on 3-13.
Change the setting of the Input Type
parameter to a resistance thermometer in
the Initial Setting Level.
Or
Connect a temperature sensor.
Refer to step 2 on 3-13.

Other manuals for Omron E5CC-800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron E5CC-800 and is the answer not in the manual?

Omron E5CC-800 Specifications

General IconGeneral
CommunicationRS-485 (optional)
Protection RatingIP66 (front panel)
Input TypeThermocouple, RTD, analog input
Output TypeRelay, voltage, current
Supply Voltage100-240 VAC, 24 VAC/VDC
Size48 x 48 mm
Control OutputRelay, voltage, current
Ambient Operating Temperature55 °C
Control MethodON/OFF, 2-PID
Ambient Operating Humidity35 to 85% RH (non-condensing)
MountingPanel mount

Related product manuals