Omron E5CN - Page 219

194
Initial Setting Level Section 5-7
• This parameter sets the transfer output type.
• The operation is shown in the following table.
■ Transfer Output Destination
■ Precision and User Calibration
]
■ Related Parameter
Transfer output upper limit, Transfer output lower limit (initial setting level):
Page 195
tr-t Transfer Output Type
There must be a transfer output or a
current output.
Control output 1 Control output 2 Transfer output
destination
Current output • No
• Relay output
• Voltage output (for driving
SSR)
Control output 1
• Relay output
• Voltage output (for driving
SSR)
•No
• Relay output
• Voltage output (for driving
SSR)
No
Precision User calibration
Simple transfer output Not specified. Not supported.
Transfer output type Default
OFF off off
Set point sp
Set point during SP ramp sp-m
PV pv
MV monitor (heating) mv
MV monitor (cooling) c-mv
Setting
See
See