3-113
3 Functions of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3-6 Parts
3
3-6-9 Animation
Read Address Assignment:The word address specifying the position on the path which was
set previously is set automatically to Read Address + 1.
Address: Refers to the first address of the word address corresponding to the Animation
component.
Word Length: Displays the data length of the read address, which is fixed to “2”.
4
Switch to the [Animation] tab.
State No.: Selects the total states displayed by the Animation component. It determines the
number of states of the Vector Graphics or bitmap displayed in the preset path.
Add Node: Adds one moving node in the end of the preset path.
Insert Node: Inserts one moving node after the moving node pointed by the mouse.
Delete Node: Deletes one moving node.
Move Up:
Moves the moving node pointed by the mouse into the place before the previous node.
Move Down: Moves the moving node pointed by the mouse into the place after the next node.
Graphics Size (Width/Height): This is the size of Animation Components displayed on the
path. On all moving nodes, vector graphics or bitmap are
displayed in the state which was resized with the parameter
specified by this item.
Moving Node List: Displays all the numbers and coordinate values for all the track nodes, and
No.0 is for the 1
st
moving node, and No.1 is for the 2
nd
moving node, and so
on. The total number of the moving node is determined by the number of
moving node when you put the component in the PT at the beginning. X(Y)
represent the coordinate position corresponding to the moving node, and
you can reset the coordinate position for each moving node here.
5
Switch to the [Label] tab and add the corresponding texts to be displayed.
Read Address States of Vector Graphics or bitmap
Read Address + 1 Position No. in the preset path.
To Next Page
Loading...
Need help?
General
