3-127
3 Functions of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3-6 Parts
3
3-6-13 Text Display
The Text Display component can display data in the specified word memory, which is
analyzed through the standard ASCII character table in default settings. Low-byte character codes are
displayed on the left, while high-byte character codes are displayed on the right.
Process of adding one Text Display component
1
Press the Text Display component icon, drag it to the window, then the [Basic Properties] dialog
box of the Text Display component will pop up.
Swap high byte and low byte: Refers to the interchange of the high byte and the low byte for
the same byte, as shown below.
Unicode: If you check in the check box for this function, the specified data is dealt as Unicode.
Extended ASCII: Checking this option can display the extended ASCII characters between
0×80 and 0×ff in the ASCII codes. When it is checked, Chinese can’t be
displayed in the Text Input component, Text Display component and Note
Book component. Only one of [Unicode] or [ASCII] can be selected.
Read Address: Refers to word address memory of PLC to be displayed (It contains up to 16
words, each of which contains 2 ASCII codes).
3-6-13 Text Display
To Next Page
Loading...
Need help?
General
