Omron NS - SETUP User Manual

2-1 Connecting the Host
2-7
Supported communications
methods
NS-
series
PT
commu-
nications
Host
commu-
nications
Supported connection methods
1:1
NT
Link
1:N
NT
Links
FINS
Ether-
Net/IP
Data
Links
Refer-
ence
page
RS-232C,
Controller
Link
RS-232C,
Controller
Link
Host
PT
Serial port A
RS-232C cable
Host
Controller Link
Controller Link
Interface Unit
Specified shielded twisted-pair cable
Yes Yes Yes Yes Yes
P. 4-2
P. 4-11
P. 5-26
Ethernet,
Controller
Link
Ethernet,
Ether-
Net/IP,
Controller
Link
Host
PT
Ethernet
Host
Specified shielded twisted-pair cable
10BASE-T/100BASE-T
Twisted-pair cross cable
Controller Link
Interface Unit
Controller Lin
k
No No Yes Yes Yes
P. 5-2
P. 5-17
P. 5-26
Yes: Connection is possible. No: Connection is not possible.
Note: Only when a Controller Link Interface Unit (NS-CLK21) is mounted.
• The NS-AL002 is connected directly to the serial port of the PT and power is supplied
from pin 6 of the port.
• When there are multiple serial ports and Ethernet Units for a single host, each port can
be used to communicate with separate PTs. This type of communications method,
however, will reduce the communications performance at the host.

Omron NS - SETUP Specifications

General

Brand	Omron
Model	NS - SETUP
Category	Touch terminals
Language	English