27
Installation
Section 2-2
2-2 Installation
Install the NT20S to the operation panel and connect the power to the NT20S as
described below.
2-2-1 Installation Environment
Observe the following points when installing the PT in an operation panel.
Caution: Do not install the NT20S at sites subject to the following conditions.
Otherwise, the product may malfunction.
S Severe temperature variations
S Temperatures or humidities outside the ranges stated in the specifications
S High humidity, condensation
S Splashing chemical agents
S Severe oil splashing
S Corrosive or flammable gases
S Strong vibrations or shocks
S Direct exposure to wind and rain (outdoor sites)
S Strong ultra-violet irradiation
Take adequate measures to ensure shielding if the NT20S is used at a location
subject to any of the following conditions.
S Static electricity, or noise from other equipment
S Strong electric or magnetic fields
S Nearby power cables
S Potential exposure to radioactivity
To Next Page
Loading...
