EasyManuals Logo

Omron NT20S User Manual

Omron NT20S
308 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
DIP-SW Status
Init. Memory
Memory Switch
Comm. Type
Key Sound
Buzzer Sound
Host Link
OFF
Bk light Off
Tool Mode
OFF
None
NT20M
(1/2)
Quit
WRT&
EXIT
MEMORY SW MENU
Page
Automatic Reset
Baud Rate
No
9600bps
(2/2)
Quit
WRT&
EXIT
MEMORY SW MENU
Page
79
Setting the Conditions of Communications with the PC/Host by Using the Memory Switches
Section 3-5
3-5-2 Selecting the Host Link Communication Speed
(NT20S-ST121-EV3 only)
When using the NT20S-ST121-EV3 with the host link, the baud rate of the com-
munications with the PC can be set. Use the “Baud Rate” switch and select 9600
bps or 19200 bps.
The factory setting has been made at 9600 bps.
Select the baud rate of the communication with the PC by the menu operation from
the System Menu as mentioned below.
Select “Maintenance Mode”.
Select “Memory Switch”.
Select “Page”.
If the host link is not selected,
press the “Comm. Type” touch
switch and select “Host link”.
Each time the “Baud Rate”
touch switch is pressed, the set-
ting option alternates between
“9600 bps” and “19200 bps”.
To set and quit the menu, press the [WRT&EXIT] touch switch. To quit without set-
ting, press [Quit].

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NT20S and is the answer not in the manual?

Omron NT20S Specifications

General IconGeneral
BrandOmron
ModelNT20S
CategoryTouch terminals
LanguageEnglish

Related product manuals