Subtree name Standard [(identifier) attribute] Support
Implementation spec-
ifications
ipRouteEntry [(1) NA]
Route information for a specific destination.
The index is ipRouteDest.
--- ---
ipRouteDest [(1) RW]
The destination IP address for this route. A
value of 0.0.0.0 for this entry indicates the
default route.
Support-
ed
According to the stand-
ard.
ipRouteIfIndex [(2) RW]
The ID number of the interface required to
send to the next destination host in this route.
This ID number is the same number as ifIn-
dex, which is used to identify the interface.
Support-
ed
According to the stand-
ard.
ipRouteMetric1 [(3) RW]
The primary routing metric for this route. This
value is determined based on the protocol
specified in ipRouteProto. Set to -1 if you do
not want to use this metric (this is also the
same for ipRouteMetric 2 through 4).
Support-
ed
According to the stand-
ard.
ipRouteMetric2 [(4) RW]
The alternative routing metric for this route.
Support-
ed
According to the stand-
ard.
ipRouteMetric3 [(5) RW]
The alternative routing metric for this route.
Support-
ed
According to the stand-
ard.
ipRouteMetric4 [(6) RW]
The alternative routing metric for this route.
Support-
ed
According to the stand-
ard.
ipRouteNex-
tHop
[(7) RW]
The IP address of the next hop in this route
(for routes connected by a broadcast or me-
dia, this is the agent address or address of
that interface).
Support-
ed
According to the stand-
ard.
ipRouteType [(8) RW]
The type of route.
other (1): Not any of the following types.
invalid (2): An invalid route.
direct (3): A direct connection.
indirect (4): An indirect connection (not con-
nected to LOCAL).
Support-
ed
According to the stand-
ard.
14 SNMP Agent
14-12
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
To Next Page
Loading...
