Service Protocol Port number Remarks
Used by system, other TCP/UDP 9600 You can change the port number in the
Unit Settings on the Sysmac Studio.
FTP client
control port
TCP 21
NTP client UDP 123
SNMP agent UDP 161
SNMP trap UDP 162
TCP/UDP message service
(NX102)
TCP/UDP 64000
*10. A CPU Unit with unit version 1.01 or later and Sysmac Studio version 1.02 or higher are required to use CPU routing.
1 Introduction
1-11
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
1-3 Built-in EtherNet/IP Port
1
1-3-1 Specifications
To Next Page
Loading...
