Omron NX102-12 Series User Manual

Precautions for Correct Use
When you use the Sysmac Studio version 1.10 or lower, create the connections again if you
changed the target device after configuring the connection settings.

Changing the IP Addresses for All Target Devices
1 Right-click one of the connection lines and select Change Node Address from the menu.
2 The Node Address Change Dialog Box is displayed. Enter a new IP address in New IP
address.
T
o apply the same change to other connections, select the Apply the change to other
connections Check Box.
3 To apply the same change to other connections, select the Apply the change to other
connections Check Box.
4 Click the OK Button.

Changing All Target Device Information including Model Names and Revi-
sions
1 Right-click one of the connection lines and select Change T
arget Device from the menu.
2 The Target Device Change Dialog Box is displayed. Select a target device from New device.
Appendices
A-21
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
A-2 Use the Sysmac Studio to Set the Tag Data Links (EtherNet/IP Connections)
A
A-2-4 Making the EtherNet/IP Connection Settings with the Sysmac Stu- dio

Omron NX102-12 Series Specifications

General

Brand	Omron
Model	NX102-12 Series
Category	Controller
Language	English