• Set the NTP settings (enabling NTP and execution condi-
tions).
↓
2
Execute automatic clock adjustment.
• Execute automatic adjustment at specified times or specified
intervals.
• Use the Sysmac Studio to check the NTP Last Operation
T
ime and NTP Operation Result system-defined variables.
• Check the event log to see if the NTP client started.
Using the SNMP Agent
1
Use the Sysmac Studio to set the initial settings of the Ether-
Net/IP Function Module.
Section 14 SNMP Agent on page
14-1
• Set the SNMP settings.
• Set the SNMP trap settings.
↓
2
Check operation.
• Check the event log to see if the SNMP agent started.
Using BOOTP
1
Use the Sysmac Studio to set the initial settings of the Ether-
Net/IP Function Module.
Section 5 Sysmac Studio Set-
tings for the Built-in EtherNet/IP
Port on page
5-1
• Set the BOOTP settings.
↓
2
Check operation.
• Check the event log to see if BOOTP started.
• Check the Online system-defined variable.
1 Introduction
1-30
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
To Next Page
Loading...
