112
Analog Input Units Section 5-4
conversion cycle speed is increased. For details on conversion cycle time,
refer to 5-4-4 Calculating the Conversion Cycle.
Note Two words are always used for the I/O data for analog input values regardless
of the analog word setting.
Setting Procedure (Example: DeviceNet Configurator)
1,2,3... 1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Analog Input Unit that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
Conversion points Details
2 points (default) Converting Inputs 0 to 1.
1 point Converting Input 0.
0 1
All used.
GRT1-AD
0 1
Input 0 only used.
GRT1-AD2
To Next Page
Loading...
