32
Installation Section 3-1
Connecting the End
Unit
A GRT1-END End Unit must be connected to the end of the Slice I/O Termi-
nal.
Note When connecting Units, always align the guide tracks on the top and bottom
of the Units and be sure that they join properly as you slide the Unit toward
the DIN Track.
3-1-3 Installation on a DIN Track
DIN Track Installation Mount the Communications Unit and Slice I/O Units on a DIN Track. Attach
the DIN Track with screws in every fourth mounting hole.
PFP-50N (50 cm) or PFP-
100N (100 cm) DIN Track
PFP-M End Plate (Two
Required)
Attach the track with screws at a
maximum spacing of 105 mm
between ad
acent screws.
To Next Page
Loading...
