33
Installation Section 3-1
Slice I/O Terminal
Orientation
There is no particular restriction on the Slice I/O Terminal’s orientation. The
Terminal can be mounted in any of the following 6 directions.
Installing a Unit Press the Units onto the DIN Track firmly from the front. Press the Unit firmly
until it clicks, indicating that the Unit’s DIN Track Mounting Hooks have locked
onto the DIN Track.
Note It is not normally necessary to release the DIN Track mounting hook when
mounting the Unit. When the Units are installed on a DIN Track other than the
recommended track, the Mounting Hooks may not lock onto the track com-
pletely. In that case, release the Mounting Hook locks, mount the Unit on the
DIN Track again, and lock the Mounting Hooks.
Slice I/O Unit
Structure
The Slice I/O Units are made up of 3 blocks. Each block can be removed for
replacement.
Press firmly towards the DIN Track.
Press firmly until you hear a click,
indicating that the Mounting Hooks
have locked.
Mounting Hooks
When the Unit is pushed onto the DIN Track,
verify that the Mounting Hooks have locked.
To Next Page
Loading...
