34
Installation Section 3-1
Removing a Unit Use a standard screwdriver to release the DIN Track Mounting Hooks at the
top and bottom of the Unit and pull the Unit straight away from the DIN Track.
Main Block
Base Block
Terminal Block
This is the terminal block of the Slice I/O Unit.
If the main block is damaged or needs to be
replaced for any other reason, the wiring
connected to the terminal block does not
need to be removed.
This is the bus section of the Slice I/O Unit.
If the main block is damaged or needs to be
replaced for any other reason, the base block
can be left connected to the Slice I/O Terminal
so that the main block can be replaced online.
To Next Page
Loading...
