Omron SmartSlice GRT1 Series

35
Installation Section 3-1
Removing an Entire Unit
Including the Base Block
1,2,3... 1. Remove the main block of the Unit on the right side of the Slice I/O Unit
actually being replaced.
2. Release the Mounting Hook locks of the Unit being replaced. (The hooks
attach the Unit to the top and bottom of the DIN Track.)
3. Pull the Unit straight away from the DIN Track.
Removing Just a Unit’s
Main Block
Press the latches on the top and bottom of the main block and pull the block
forward.
Removing Only the
Terminal Block
Release the hooks on the top and bottom of the terminal block and pull out the
terminal block.
B
B
A
C
Unit being replaced
Press the latches on the top and bottom o
f
the main block and pull the block forward.
Release the hooks on the top
and bottom of the terminal block.