135
Analog Input Units Section 5-4
Last Maintenance
Date
The last maintenance date can be set in the Unit separately for the Unit and
the connected devices. It enables the user to easily determine the next main-
tenance date. The date can be set using the Setting Tool.
Setting Procedure (Example: DeviceNet Configurator)
■ Setting the Last Maintenance Date of the Unit
1,2,3... 1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Slice I/O Terminal that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
2. Click the I/O Module Tab.
3. Click the Edit Button on the I/O Module Tab Page. The Edit Unit Parame-
ters Window will be displayed.
4. Click the General Tab, and select the applicable date from the pull-down
menu in the Last Maintenance Date Field. (To enter the current date, se-
lect Today, which is at the bottom of the pull-down menu.)
5. Click the Download Button, and then click the Reset Button to reset the
Unit.
6. Click the OK Button to exit.
■ Setting the Last Maintenance Date of the Connected Device
1,2,3... 1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Slice I/O Terminal that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
To Next Page
Loading...
