151
Analog Output Units Section 5-5
Monitor values can also be set in the Unit. When the cumulated count value
exceeds the set monitor value, the Cumulative Counter Flag in the area for
Generic Status Flags turns ON.
Note The following table shows the divisions for the cumulative counter.
Setting Procedure (Example: DeviceNet Configurator)
1,2,3... 1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Slice I/O Terminal that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
2. Click the I/O Module Tab.
3. Click the Edit Button on the I/O Module Tab Page. The Edit Unit Parame-
ters Window will be displayed.
Analog output value
Cumulated value (count
× hour or minute)
Division width
(See note.)
Time t
Unit Divisions
Hour 3.6 s (1/1,000 hour)
Minute 60 ms (1/1,000 minute)
To Next Page
Loading...
