255
GRT1-CP1-L Positioning Unit Section 7-5
Hardware Settings The DIP switch on the board inside the Positioning Unit must be set to select
the required interface. Either a 24-V or line driver interface can be used.
The DIP switch is accessed as shown below. It has four pins.
Z, I Yellow Lit Either input Z or the digital input is ON
and the other input is OFF.
Not lit Input Z and the digital input are either
both ON or both OFF.
O0 Yellow Lit Digital output 0 is ON.
Not lit Digital output 0 is OFF.
O1 Yellow Lit Digital output 1 is ON.
Not lit Digital output 1 is OFF.
Name Color Indicator
status
I/O status
DIP switch setting Interface
All pins ON 24 V
All pins OFF Line driver
Set the interface on the DIP switch inside the
Positioning Unit. Use a flat-blade screwdriver to similar
tool to make setting the pins easier.
Release the lock levers and pull out the
terminal block.
To Next Page
Loading...
