268
GRT1-CP1-L Positioning Unit Section 7-5
■ Default Settings
Press the Default Setting Button on the General Tab Page to set the follow-
ing default values.
Preset Tab Page The Preset Tab Page is used to set the counter to a preset value. The counter
can be set to the preset value using the Action on Input Rising Edge or Action
on Input Falling Edge setting for the digital input or using the Preset Com-
mand Bit (bit 10 of word n+2).
Click the Preset Tab in the Edit Unit Parameters Window. The Preset Tab
Page will be displayed.
Setting Default value
Counter Input Mode Phase differential ×1
Action on Input Rising Edge No Action
Action on Input Falling Edge No Action
Action upon Bus Error Outputs are cleared.
Action upon Bus Idle Outputs are cleared.
Configuration tag (Not affected.)
To Next Page
Loading...
