51
Functions of Digital I/O Units Section 4-4
Setting with a
Programming Device
This example shows how to use the DeviceNet Configurator (version 2.43 or
higher) to set the input filter.
1,2,3... 1. Open the Network Configuration Window and double-click the desired
Slice I/O Terminal’s icon or right-click the icon and select Parameters -
Edit to display the Edit Device Parameters Window.
2. Select the desired Slice I/O Unit from the list on the I/O Module Tab Page
and click the Edit Button to display the Edit Unit Parameters Window.
3. Select the IN Tab, input the desired values for the ON response time (in
the ON Delay Field) and the OFF response time (in the OFF Delay Field),
and click the OK Button.
4. Click the General Tab.
5. Click the Download Button, and then click the Reset Button to reset the
Unit.
6. Click the OK Button.
To Next Page
Loading...
