39
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Preparation
≫
Playback
≫
Setup
≫
Selecting audio input signals
With AUDIO SEL on the remote controller, you can select audio input signals
assigned to each input source. Once selected, the same audio input signal is
played next time.
1. Press the input selector button to switch to the input whose assignment is
changed.
• The assignment can be changed only for "BD/DVD", "TV", "CBL/SAT" and
"CD" inputs.
2. Press AUDIO SEL, and select the audio input signal to assign.
• Each time the button is pressed, the setting item is switched among "H"
(HDMI IN), "A" (AUDIO IN), "C1" (COAXIAL1) and "O1" (OPTICAL1). Audio
input signals that can be assigned to each input source are as follows.
Input Selector
H
(HDMI IN)
C1
(COAXIAL1)
O1
(OPTICAL1)
A
(AUDIO IN)
BD/DVD
TV
(*1)
CBL/SAT
CD
STRM BOX
GAME
(*1) When selecting "A" (AUDIO IN) for "TV" input, set "3. Input Assign" - "a.
Analog Input" to "TV" on the Setup menu beforehand.
• If "H", "C1" or "O1" is selected with AUDIO SEL, but the corresponding input
signal is not present, then "A" is selected.
To Next Page
Loading...
