79
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Preparation
≫
Playback
≫
Setup
≫
General Specications
Amplier Section
Rated Output Power
With 8 ohm loads, both channels driven, from 20-20,000 Hz; rated 80 watts
per channel minimum RMS power, with no more than 0.08% total harmonic
distortion from 250 milliwatts to rated output. (FTC) (North American)
7 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC) (Others)
100 W per channel (20 Hz to 20 kHz, 8 Ω, 0.09%) (Others)
Maximum Eective Output Power (North American)
155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
THD+N (Total Harmonic Distortion+Noise)
0.06% (20 Hz to 20,000 Hz, 50 W)
Input Sensitivity and Impedance
200 mV/47 kΩ (LINE (RCA))
Frequency Response
5 Hz to 100 kHz/+1 dB, –3 dB (Direct)
Tone Control Characteristics
±10 dB, 100 Hz (BASS)
±10 dB, 10 kHz (TREBLE)
Signal to Noise Ratio
106 dB (IHF-A, LINE IN, SP OUT)
Speaker Impedance
6 Ω - 16 Ω
Video Section
Signal level
1 Vp-p/75 Ω (Composite Video)
Tuner Section
FM Tuning Frequency Range
87.5 MHz to 108.0 MHz
AM Tuning Frequency Range
530 kHz to 1700 kHz (North American and Taiwanese)
531/530 kHz - 1602/1700 kHz (Others)
Preset Channel
30
BLUETOOTH Section
Communication system
BLUETOOTH Specication version 3.0
Frequency band
2.4 GHz band
Modulation method
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH proles
A2DP
Supported Codecs
SBC
AAC
Qualcomm
®
aptX™
Transmission range (A2DP)
20 Hz - 20 kHz (Sampling frequency 44.1 kHz)
Maximum communication range
Line of sight approx. 10 m (*)
* The actual range will vary depending on factors such as obstacles between
devices, magnetic elds around a microwave oven, static electricity,
cordless phone, reception sensitivity, antenna's performance, operating
system, software application, etc.
General
Power Supply
120 V AC, 60 Hz (North American and Taiwanese)
220 - 240 V AC, 50/60 Hz (Others)