OnRobot RG2-FT - Compute Box; With 1.5 A Wall Adapter (36 W); With 5 A Wall Adapter (120 W)

NOTE:
The easiest way to check if a cardboard box is suciently tight is simply to test
it using the VG grippers.
A high vacuum percentage setting does not give a higher lifting capacity on
corrugated cardboard. In fact, a lower setting is recommended, e.g. 20%.
A low vacuum setting results in less air flow and less friction below the vacuum
cups. This means VG gripper filters and vacuum cups will last longer.
8.1.12. Compute Box
8.1.12.1. With 1.5A Wall Adapter (36W)
Supplied Wall Adapter
Minimum Typical Maximum Unit
Input voltage (AC) 100 - 240 [V]
Input current - - 1 [A]
Output voltage - 24 - [V]
Output current - 1.5 - [A]
Compute Box Power input (24V connector) Minimum Typical Maximum Unit
Supply voltage - 24 25 [V]
Supply current - 1.5 - [A]
Compute Box Power output (Device connector) Minimum Typical Maximum Unit
Output voltage - 24 25 [V]
Output current - 1.5 - [A]
8.1.12.2. With 5A Wall Adapter (120W)
Supplied Wall Adapter
Minimum Typical Maximum Unit
Input voltage (AC) 100 - 240 [V]
Input current - - 2 [A]
Output voltage - 24 - [V]
Output current - 5 - [A]
Compute Box Power input (24V connector) Minimum Typical Maximum Unit
Supply voltage - 24 25 [V]
Supply current - 5 - [A]
HARDWARE SPECIFICATION
228