OpenScape CP200 - Activating and Deactivating the Hold Reminder Tone; Setting the Hold Reminder Time

108
Activating and deactivating the hold
reminder tone
z You can also configure this setting via the WEB-Oberfläche  page 132.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Setting the hold reminder time
Use the "Hold rem. delay" function to set the time after which you want to receive
an automatic reminder about a held call.
The minimum value is 3, in other words the reminder is output after three min-
utes. The maximum value is 15 minutes.
z You can also configure this setting via the WEB-Oberfläche  page 132.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
μ€ Select a value between 1 and 15 and confirm.
Select and confirm the option shown.
User
Configuration
Connected calls?
Allow hold rem. = No f
Yes l
Save & exit l
User
Configuration
Connected calls?
Hold rem. delay=3 f
Save & exit l