OpenScape CP200 - Allowing Busy When Dialling; Allowing Transfer on Ring

115
Allowing Busy when dialling
If you activate this function, an incoming call received while you are dialing is re-
jected. The caller then hears the busy signal.
z You can also configure this setting via the WEB-Oberfläche  page 132.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Allowing Transfer on ring
If this option is allowed, you can activate call transfer by replacing the handset
even before the called party answers.
z You can also configure this setting via the WEB-Oberfläche  page 132.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Confirm the option shown to activate the callback function.
Select and confirm the option shown.
User
Configuration
Outgoing calls
Busy when dialling = No m
Yes l
Save & exit l
User
Configuration
Outgoing calls
Transfer on ring = No m
Yes l
Save & exit l