OpenScape CP200 - Connecting Parties; Placing a Call on Hold

42
Retrieving the second call
€ Switch to the held consultation or second call.
Ç Press the flashing key. You are connected with the other party. The first called
was put on "Hold" again.
Connecting parties
You can connect the first party with the party you consulted, clearing down your
connection to both parties in the process.
Prerequisite: You are conducting a consultation call
 page 39 and call joining
is allowed
 page 110.
Select and confirm the option shown.
The active and held calls are joined. You are disconnected from the call.
or Connecting by hanging up
] or : Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Placing a call on hold
You can use this function to place an ongoing call on Hold, for instance to pre-
vent the other party overhearing a conversation with a colleague in the same
room.
Prerequisite: You are conducting a call.
Select and confirm the option shown in the connection's context menu.
or
Ä Press the key shown. The key illuminates.
Retrieving a held call
Select and confirm the option shown in the connection's context menu.
or
Ç Press the illuminated key.
Using line keys
On a multi-line telephone, you can also use the line keys to place ongoing calls
on Hold.
Press the corresponding line key. The line key LED starts flickering. The call is
now on hold.
Retrieving a held call:
Complete Xfer? f
Hold ? f
If you do not retrieve the held call after a defined time interval, a reminder
beep sounds three times and a prompt to retrieve the call or disconnect
appears on the display. The settings for this can be found on
 page 108
and
 page 108.
Reconnect ? l
Line 1
_