OpenScape CP200 - Call Waiting (Second Call)

43
Press the corresponding line key. The line key LED lights up. The call is re-
trieved.
Held call wait status
After placing a call on hold, you can replace the handset and then decide wheth-
er to retrieve the call or disconnect.
Prerequisite: You placed a call on hold and replaced the handset or pressed
the loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu appears on the display:
Select and confirm the option shown to retrieve the call in speakerphone mode.
or
Select and confirm the option shown to disconnect the held call.
Call waiting (second call)
You can accept a second incoming call in the course of an ongoing call. The call-
er hears the on-hook signal while you hear a call-waiting signal tone. A bell ap-
pears on the display and next to it the phone number of the caller is shown.
You can ignore or accept the second call. Before you accept the second call, you
can end the first call or place it on hold for subsequent retrieval.
You can block the second call or the signal tone (
 page 112).
Answering a second call
Prerequisite: You are conducting a call and call waiting is allowed
(
 page 112).
Select and confirm the option shown.
You can talk to the second party.
The connection to the first party is on hold.
During the call with the second party, additional functions are available for selec-
tion:
• Alternate (see
 page 40),
• Complete transfer (see
 page 42),
• Conference (see
 page 40),
• Blind transfer (see
 page 45),
• Hold (see
 page 42).
• Put on hold and retrieve second and first call successively
 page 41
Consultation call from second call
If the second call is your active call you can initiate a consultation call from it.
Line 1
¤
The LED display  page 67 indicates that the call is on "Hold" to other
multi-line telephones where this line is also configured. These phones can
then pick up the call.
Retrieve held call ? l
Disconnect ? f
If you enabled Hold and hang-up" ( page 109), the call is placed on hold
for a defined time interval (
 page 108) before the prompt is displayed
with a recall to retrieve the call or disconnect. You can however retrieve the
call or disconnect via the context menu before the defined time expires.
This function cannot be used on multi-line phones.
Accept l